Radios
Options
LesComm Kits
Kit Instructions
LCTS U-tube link
LesComm LC148F-LTDII & LTD
Used Radios for sale

LesComm improved DX959B
LesComm improved DX959B
LesComm improved DX959B
Item#: DX959B
Regular price: $289.99
Sale price: $249.99

Product Description
LesComm improvements INCLUDE Power Buffer/Filter capacitor upgrades, Schottky Diode upgrade (if needed), 1st RF amp upgrade, 10.7 I.F. filter upgrade. Complete Peak and Tune. ****SEE AVAILABLE OPTIONS BELOW**** DX959B Specifications; Blue Frequency Display Blue Channel Display RB and RX LED's Blue StarLite Faceplate (Glow-in-the-Dark red and blue lettering) Large, easy-to-read meter with 4 scales: "S" Meter indicates up to 60 dB over S9 Modulation Percentage Scale for use on AM Power Scale Calibrated for AM and SSB SWR Scale Automatic SWR Circuit (no complicated calibration procedure) "Talkback" Circuit with On/Off Switch and Volume Control Variable Power Output Control Roger Beep with On/Off switch and LED Indicator Galaxy Noise Filter for use on weak signals High SWR Alert LED Indicator Two Year Warranty as explained below: Five-digit Frequency Display +/- 1.0 kHz Receive Clarifier Noise Blanker and Automatic Noise Limiter AM, SSB and PA Modes 3-Position Tone Control Switch Blue/Red LED Indicator for RX/TX Blue LED Channel Indicator Dimmer Control Receive Gain Control Mic Gain Control Please note, the StarLite lettering is always at full brightness because it is not very intense - even in the dark. It is designed to let you know where the controls are, but not be too bright. The back lighting may be turned off using the Display Push switch but the brightness level is not affected by the Dimmer pot. The StarLite lettering is always at full brightness when it is on. The blue digits of the frequency display and channel display can go from very bright to very dim using our high resolution dimmer circuit. The Dimmer control pot on the DX959B starts dimming almost immediately when you start turning it down from maximum. On some radios, the dimming effect is not even noticeable until you turn the pot a quarter or half turn. This one starts dimming immediately and dims continuously down to where you can barely notice the digits are on. This is perfect for night driving. You make the digits exactly as bright as you like them. Of course, the digits can be shut off completely with the Display Push switch. Only one Channel Kit can be ordered with each radio. Pricing includes installation. ****TRB-X3 Echo option replaces the Talkback control and deletes talkback. *An Amateur License is required to transmit in the Amateur bands. You are responsible for the legal operation of your radio equipment.
Accessories
Top Gun Tech CP-1
Product Description
Now the same Top Gun Compressor CP-1 circuit used in the new Magnum radios are available for most other 10-meter and many CB radios. Full tone, clear, high swing audio (AM) modulation is achieved with the Top Gun Compressor. Works in AM, FM, and SSB keeping the modulation at peak performance in all these modes. Installation is included.

$30.00
TGTCP1

Clarifier Mod
Product Description
This option locks your TX/RX together. Makes the Clarifier control both TX/RX frequency together. Highly recommended!!! Don't be one of those guys that sounds like Mickey Mouse when he yells CQ_DX! Keep your transmitter and receiver locked together. As one that almost exclusively operates on side band, this mod is a must! It is annoying when someone QSK's into a conversation that is totally off frequency. Then everyone tells them they're off frequency but he is unable to tune his transmit to where he hears everyone else talking. So he inevitably gets ignored. With your clarifier controlling both TX & RX at the same time, where you hear operators talking is where your transmit will be sending.

$24.99
Clarifier Mod ClarifierMod

LesComm Deluxe Ten Turn Clarifier
Product Description
Replaces the Clarifier with a 10 turn precision control. On the DX959 and 2547, adds the LesComm Deluxe clarifier Option for more slide. +/-6KCs.

Due to the size of the 10 turn potentiometer;

On the LC995v2 it replaces the Echo control.

On the LC994v100 & LC998v200 it replaces the Talkback control. Talkback is moved to the old clarifier position.

$50.00
LsCmTenTurn

Galaxy/Texas Ranger Dual Final upgrade
Product Description
Adds a second IRF520 MOSFET Final with Heatsink and supporting components.

$55.00
GLXYTXRNGRDFU

LesComm Personalized Face Decal
Product Description
This option allows you to change the color of the face decal and add limited personalization.

$30.00
LsCmPersFaceDcl
Color: 

Your Radio Build Video
Product Description
I will create a video of your radio build.

Note; No returns on video.

Regular price: $30.00
Sale price: $22.50
YourRBV1

The RMI AD-203 MOSFET Amp
Product Description
Internal 4 MOSFET AMP. Produces a little over 100 watts peak. Replaces the internal speaker for a clean installation.

**Does not replace speaker in the 2547.

$125.00
RMIAD203

LC35-128 Galaxy - Ranger
Product Description
LC35-128 Galaxy-Ranger version Product Description Designed to compete directly with the Galaxy-Viagra board. Gives 3 band coverage but also has a +10kc switch to get those "A" channels the Viagra kit doesn't! Unlike the Viagra kit, it uses the PLL to obtain the additional frequencies therefore eliminating all of the problems with the Viagra board. All bands use one clarifier circuit and forget about adjusting 6 coils to get all modes on frequency on Hi and Lo bands! The PLL circuit locks in those channels and modes just as it does for the regular CB channels! Yet, it retains the ability to upgrade. On the Galaxy radio's, it can use the NB/ANL switch. For the Galaxy 2547, 939 or 959-DX but will fit any radio with the same board. Such as the Ranger Freedom-One TR696, 936, 966, 969 and the Texas Ranger 396. Simply change the crystal X3 with the one in the kit, unplug the NB/ANL or TONE switch and plug it into the board. Then unplug the channel selector cable and plug into the LC35, plug the LC35's cable into the main board. You're done!! No more center frequency shifts when you change bands because the switching is done in the PLL, not with crystals. The Microprocessor has a built in oscillator so changes happen lightning fast. WARNING! This unit is Not Legal For Class D CB Use In The U.S.A. *An Amateur License is required to transmit in the Amateur bands. You are responsible for the legal operation of your radio equipment.








Regular price: $90.00
Sale price: $70.00
LC35-128 Galaxy - Ranger LC35-128GR

192 CHANNEL UPGRADE FOR THE LC35
Product Description
This option upgrades your LC35-128 to an LC35-192. It increases your number of channels from 128 to 192. It uses a 5 position rotary switch instead of the toggle.

NOTE! Must be ordered at the same time as your kit. Cannot be added later.

WARNING! This unit is Not Legal For Class D CB Use In The U.S.A.

*An Amateur License is required to transmit in the Amateur bands. You are responsible for the legal operation of your radio

Regular price: $50.00
Sale price: $30.00
192 CHANNEL UPGRADE FOR THE LC35 192CHUPGD

LC5304 Expansion Board
Product Description
No "encoder" required. I wrote code in the software that allows the use of the Channel Selector switch to go up or down. It even deals with the out-of-sequence steps around channel 23. This means you won't need to rebuild the channel selector area of your radio to have a 3 digit display! As promised - easy installation. Galaxy 9X9's are still Plug & Play. ** Uniden made radios such as Cobra and others will still need the adapters so soldering is required on these. Continuous channel tuning. No skips. Buyers choice. Uniden made radios; Lo-26.065 to 27.975 or Hi-26.815 to 28.725. Uniden/Cobra Ranger made radios; Lo-26.065 to 27.975 or Hi-26.695 to 28.605. Ranger/Galaxy You can choose to use either band. The display will track the frequencies/channels correctly. Both the 11.1125 and 11.3258 in Cobra's. Or swap the crystal for 26.065 to 27.975. SquelchScanTM. Scan Up or Down. Scan stops when a signal is received. Hi Range; Channel 1 Reference; -15 / c19 / 172 (26.815 to 28.725)Uniden/Cobra Channel 1 Reference; -27 / c19 / 160 (26.695 to 28.605)Ranger/Galaxy OR Lo Range; Channel 1 Reference; -90 / c19 / 97 (26.065 to 27.975) "-" indicates all channels below 1 "u" indicates all channels above 40 "c" e.g. c19, indicates cb channels. A's are 03A, 07A, etc.) Channel Selector Function (CSF) switch. Changes the channel selector to your band switch. Jumps 45 channels Up or down with each click. The displays will be available in either Blue-35mcd, Red-30mcd or Green-25mcd. *New Pure Green-35mcd. Price includes internal Piggy-back PCBoard kit (to replace internal channel display) See above. ** Internal display will require soldering. This kit is assembled after your order is received. Please allow for assembly time. WARNING! This unit is Not Legal For Class D CB Use In The U.S.A. *An Amateur License is required to transmit in the Amateur bands. You are responsible for the legal operation of your radio equipment.

$125.00
lc5304-expansion-b5304
Color:  Radio Model:  Frequency Range: 

The LC6404 Expansion Board
Product Description
No "encoder" required. I wrote code in the software that allows the use of the Channel Selector switch to go up or down. It even deals with the out-of-sequence steps around channel 23. This means you won't need to rebuild the channel selector area of your radio to have a 3 digit display! **As promised - easy installation. Galaxy 9X9's are still Plug & Play. Uniden made radios such as Cobra and others will still need the adapters so soldering is required on these. **Continuous channel tuning. No skips. Cobra=26.065 to 27.975 or 26.815 to 28.725. Galaxy coverage depends on model. Buyers choice.You can choose to use either band. The display will track the frequencies/channels correctly. Both the 11.1125 and 11.3258 in Cobra's. Or swap the crystal for 26.065 to 27.975. **SquelchScanTM. Scan Up or Down. Scan stops when a signal is received. **There are 2 display modes available accessed via a switch. Display modes are; Frequency = 6.96 (26.965-CB Ch 1) CB Ch 1 Reference = -90 thru u97 (Kit crystal) - indicates all channels below 1 u indicates all channels above 40 e.g. c19, indicates cb channels. A's are 03A, 07A, etc.) The displays will be available in either Blue-35mcd, Red-30mcd or Green-25mcd(dim). New Pure Green-35mcd. **Another new feature is the 5-Memory Channel feature. Using Store and Get on a SPDT momentary switch. One way stores it, the other selects it and the radio jumps to it. Stores up to 5 channels for instant recall. **There's a Band UP/Down feature. The CSF switch changes your channel selector to a band switch. Jump 45 channels up or down with the click of the channel selector. **Price includes an internal PCBoard display kit (to replace internal channel display,but not required). Internal display will require soldering.

This kit is assembled after your order is received. Please allow for assembly time.

WARNING! This unit is Not Legal For Class D CB Use In The U.S.A. *An Amateur License is required to transmit in the Amateur bands. You are responsible for the legal operation of your radio equipment.

$175.00
the-lc6404-expansion-b6404
Color:  Radio Model:  Frequency Range: 

LED Color Change
Product Description
Change the LED Displays color

$100.00
LEDCOLR
Color: 

Top Gun Tech SP-1a Speech Processor
Product Description
The SP-1a Speech Processor was developed by Clear Channel Corporation for the Ranger AR-3300 and AR3500 radios. It works well in most radios in AM FM & SSB. It is an audio processor that delivers an average of 90% modulation. It boosts lower levels to within 90% of itís maximum output with a very low distortion. It connects in-line of the audio Mic input of the microphone jack. It also requires a 12 Volt connection in the radio. A SPST switch can be used to switch the SP-1a in and out of the circuit. When switched off the speech processor is completely out of the circuit leaving the radio back to stock audio. Price includes installation.

$100.00
Top Gun Tech SP-1a Speech Processor TGSP1a